RayeR 0 Report post Posted September 13, 2007 Hi, I tried new betas yesterday and found strange strings/chars (I can see CR+LF and other binary rubbish) in drive select dialog. It happened in Win98 dosbox and also in MSDOS 7.1 (LFN, FAT16/32). Under MSDOS 6.22 FAT16 it's OK. I have also older version 2.30.4000 DOS which works OK. Check this screenshots: Share this post Link to post Share on other sites
Zaimskih 0 Report post Posted September 17, 2007 Check NDN.DES file Share this post Link to post Share on other sites
Garl 0 Report post Posted September 17, 2007 and as way Check *.lng and *.dlg file (owerwrite it from arhive) Share this post Link to post Share on other sites
RayeR 0 Report post Posted September 17, 2007 I don't understand, I just downloaded file from here, unpack it and run. There's no files from older version. Or do you mean I should replace this files from beta x.4000? Share this post Link to post Share on other sites
Garl 0 Report post Posted September 17, 2007 that is problem in D32 resource file ! Share this post Link to post Share on other sites
Garl 0 Report post Posted September 17, 2007 Problem in source: ENGLISH LANGUAGE: - Language (dl*) TYPE count: 1038 Reading language TYPE resource: resource\english\ndn.dnl Writing bin\D32\english.lng - Dialog (dlg*) TYPE count: 105 Reading dialog resource: resource\english\ndn.dnr (5335) Reading editor command resource: resource\edcom.dnr StoreResource: Duplicate definition for "DLGGLOBALSETUP" Error! But if make Options - Configuration - Interface - DISKINFO: (LABELS)OR (ndn.des) ALL WORK FINE! Share this post Link to post Share on other sites
RayeR 0 Report post Posted September 17, 2007 Can I use this files fron Win32 version? I'll check it at evening... Share this post Link to post Share on other sites
RayeR 0 Report post Posted September 17, 2007 Yes, DISKINFO: LABELS works OK, I'll look forward to next beta :) Share this post Link to post Share on other sites
RayeR 0 Report post Posted October 24, 2007 I tried new beta 2.30.7187 before few minutes and drive selection dialog is now OK, thanks. Share this post Link to post Share on other sites